• Remove printer from packaging
• Load Drug Label roll into printer
• Connect power and USB lead to PC
• Turn on Printer
• When LED turns Green, press Feed button to align roll
• Allow windows to detect the Printer
• If Windows doesn't install the driver, manually download the following driver Printer Driver
• Run the "DriverWizard.exe" file and follow the on-screen instructions to Install the Drivers.

Printer configuration

• Enter Printer Properties (screenshot below)
• Click on ‘Advanced’ tab
• Click on ‘Printing Defaults’
• Printing Default screen will appear
• On the Page Setup tab, Stock, Click ‘New’ Stock name, “Drug Label”
  • Label Size;
    • Width: 69.00 mm
    • Height: 36.00 mm (single)
    • Height: 50.00 mm (double)
  • Exposed Liner Width; Left: 0.00 mm Right: 0.00 mm
• Go to 'Stock' tab
• Set 'Sensor Type' as 'Transmissive'
• Set Label Gap to '4.00mm'
• Click ‘Ok’

N.B. if labels do not feed correctly with these settings after restarting the printer, change the Sensor Type to 'Reflective'

Set Orientation:

• Set ‘Portrait’ for label printing upright to user (able to read print as label leave printer)
• Set ‘Portrait 180’ for label printing upside down to user (text prints upside down to user)
• Click Ok to close ‘Advanced’ tab

Printing Preferences

• Click on ‘General’ tab
• Click on ‘Printing Preferences’
• Set Stock Name (select the Drug Label config you just created)
• Set Orientation (as per selection used in the previous step)
• Click ‘Ok’
• Click ‘Ok’

Printer roll configuration complete.