OKI 3320 - How to Configure Printer
If the receipt paper is not printing the information correctly, please follow the below steps to reconfigure. Also, make sure the grey lever on the right-hand side is pulled towards the user:
-
Hold shift, and press SEL (menu light comes on)
-
Press LF, it should read Emulation mode Epson FX, if it does not, press TEAR repeatedly until it reads Emulation mode Epson FX.
-
Continue pressing LF until it reads REAR FEED – LINE SPACING 8LPI, if it does not, press the TEAR button repeatedly until it reads REAR FEED – LINE SPACING 8LPI.
-
Press FF/LOAD – It should read FORM TEAR OFF 500ms, if it does not, press the TEAR button repeatedly, it will cycle through the options. Stop when it reads FORM TEAR OFF 500ms
-
Press FF/LOAD again, It should read SKIP OVER PERFORATION set to NO, if it does not, press TEAR button repeatedly until it reads SKIP OVER PERFORATION set to NO
-
Press FF/LOAD again, PAGE LENGTH needs to be set to 8'inches, if it does not, press TEAR button repeatedly until it reaches 8'inches.
-
Press SEL while pressing and holding SHIFT (menu light goes off)
OKI 3320 Images
-
Control Panel - Used to configure the printer
-
Paper Level - Should always be pulled towards the user (when facing the OKI)
-
Paper Roller - Used to move the paper up and down